Canon MX360 Seires - Page 802

Check ink
U163
The ink has run out.
Replace the ink cartridge and close the Scanning
Unit (Cover).
If printing is in progress and you want to continue
printing, press the machine's
Stop
button for at
least 5 seconds with the ink cartridge installed.
Then printing can continue under the ink out
condition.
The function for detecting the remaining ink level
will be disabled.
Replace the empty ink cartridge immediately after
the printing. The resulting print quality is not
satisfactory, if printing is continued under the ink
out condition.
Note
If the function for detecting the remaining ink
level is disabled,
is displayed on the
LCD.
Routine Maintenance
Since the information contained in the fax
may be lost if it is printed in this condition, the
received fax will not be printed and will be
stored in the machine's memory until the ink
cartridge is replaced. You must manually
print out faxes that were stored in the
memory. You can change the setting so that
the received fax is forcibly printed out instead
of being stored in the memory, but all or part
of the fax information may not be printed
because of the ink out condition.
Contact service center
The ink absorber is almost full.
Press the machine's
OK
button to continue
printing. Contact the service center.
Printer error has occurred
5B00
The machine error has occurred.
Contact the service center.
Timeout error
Press [OK]
Some errors occurred while copying and a certain
time passed.
Press the
OK
button to dismiss the error, and try to
copy again.
Incompatible device
Disconnect the cable from direct print port
Check the device connected to the Direct Print
Port. Printing photos directly is possible with a
PictBridge compliant device or the optional
Bluetooth Unit BU-30.
A communication time out occurs if an
operation takes too long or if it takes too much
time to send data. This may cancel printing. In
such cases, disconnect and reconnect the
USB cable.
When printing from a PictBridge compliant
device, depending on the model or brand of
your device, you may have to select a
PictBridge compliant print mode on the device
before connecting it to the machine. You may
also have to turn on your device or select Play
mode manually after connecting the device to
the machine. Perform necessary operations
before connecting your device referring to its
instruction manual.
If the error is still not resolved, check if you can
print another photograph.
Failed to scan the head alignment sheet
Press [OK]
Scanning the print head alignment sheet has
failed.
Press the
OK
button to dismiss the error, then
Seite 802 von 922 SeitenAn Error Message Is Displayed on the LCD