take the actions described below.
Make sure that the print head alignment sheet
is set in the correct position and orientation on
the Platen Glass.
Make sure the Platen Glass and the print head
alignment sheet are not dirty.
Make sure the type and size of loaded paper is
suitable for Automatic Print Head Alignment.
For Automatic Print Head Alignment, always
load one sheet of A4 or Letter-sized plain
paper.
Make sure if Print Head nozzles are clogged.
Print the nozzle check pattern to check the
status of the Print Head.
Routine Maintenance
If the error is not resolved, connect the machine to
the computer and align the Print Head on the
printer driver.
Aligning the Print Head Position
Unsupported USB hub
Remove hub
If a PictBridge compliant device is connected via a
USB hub, remove the hub and connect it directly to
the machine.
Printer error has occurred
Contact service center
B200
Turn off the machine, and unplug the power cord
of the machine from the power supply.
Contact the service center.
Important
If you disconnect the power plug, all the faxes
stored in the machine's memory are deleted.
Printer error has occurred
****
"****" is displayed in the alphanumeric character
and depends on the error occurred.
5100 is displayed:
Cancel printing, turn off the machine. Then
clear the jammed paper or protective material
that is preventing the FINE Cartridge Holder
from moving, and turn on the machine again.
Important
Be careful not to touch the components
inside the machine. The machine may
not print out properly if you touch it.
If the problem is not resolved, contact the
service center.
In other cases:
Turn off the machine, and unplug the power
cord of the machine from the power supply.
Plug the machine back in and turn the
machine back on.
If the problem is not resolved, contact the
service center.
Important
If you disconnect the power plug, all the
faxes stored in the machine's memory
are deleted.
Load paper
Load paper and press [OK]
Reload the paper correctly and press the
OK
button.
Note
When sending faxes before printing out
received data, press the
Stop
button to
Seite 803 von 922 SeitenAn Error Message Is Displayed on the LCD