Canon MX360 Seires - Page 804

resolve the error. After you press the Stop
button to resolve the error, ensure to press
the
FAX
button in order to print out data
remained in the machine's memory.
Document in ADF
Press [OK]
The document is jammed in the ADF. Remove the
document page jammed in the ADF, then press
the
OK
button. Operate again after resolving the
error.
Document Jams in the ADF
Failed to scan document
Press [OK]
No document in the ADF.
Press the
OK
button to resolve the error, then
operate again after loading documents.
Close the feeder cover
[OK] ->Eject the document
Documents remain in the ADF.
Press the
OK
button to eject documents and
press the
Stop
button to stop ejecting.
To continue scanning, operate on the application.
The scanning from the ADF may not be supported
depending on your application software. For
details, refer to the instruction manual of your
application.
Document too long
Press [OK]
The document is too long or is jammed in the
ADF.
Remove the document page jammed in the ADF,
then press the
OK
button. After resolving the error,
make sure that the document you are loading
meets the machine's requirements before redoing
the operation.
Document Jams in the ADF
Check page size
Press [OK]
Paper other than A4, Letter, or Legal-sized paper
or 8.5 x 14 inches paper is loaded.
Load A4, Letter, or Legal-sized paper or 8.5 x 14
inches paper.
Open the paper output tray
[OK] ->Continue printing
Open the Paper Output Tray, then press the
OK
button.
Cover is open You opened the Scanning Unit (Cover) during an
operation.
Return the Scanning Unit (Cover) to its original
position.
Paper jammed
Clear paper jam and press [OK]
If paper has jammed in the machine, clear the
jam, reload the paper in the machine correctly and
then press the
OK
button.
Paper Jams
Data error
Press [OK]
A power failure has occurred or the power cord
has been unplugged when the faxes are stored in
the machine's memory.
Important
If a power failure occurs or you unplug the
power cord, all faxes stored in the machine's
memory are deleted.
For details on how to unplug the power cord,
see
Notice for Unplugging the Power Cord
.
Press the
OK
button.
Page top
Seite 804 von 922 SeitenAn Error Message Is Displayed on the LCD