Advanced Guide
>
Scanning
>
Scanning with Other Application Software
>
Scanning with Advanced
Settings Using ScanGear (Scanner Driver) > Scanning Multiple Documents from the ADF (Auto Document
Feeder) in Advanced Mode
S209
Scanning Multiple Documents from the ADF (Auto Document
Feeder) in Advanced Mode
Use the Advanced Mode tab to specify the image brightness, color tone, etc. and scan multiple
documents placed on the ADF (Auto Document Feeder) at one time.
When scanning from the ADF, documents are scanned without preview.
1.
Place the documents on the ADF, then start ScanGear (scanner driver).
Placing Documents (ADF (Auto Document Feeder))
Starting ScanGear (Scanner Driver)
2.
Click the Advanced Mode tab and select Document (ADF Simplex) for Select
Source.
Note
Settings are not retained when you switch modes.
3.
Set Input Settings.
Input Settings
4.
Set Output Settings.
Output Settings
5.
Make image corrections and color adjustments as required.
Image Settings
Color Adjustment Buttons
6.
Click Scan.
Starts scanning.
Seite 551 von 922 SeitenScanning Multiple Documents from the ADF (Auto Document Feeder) in ...
To Next Page
Loading...
