Canon MX360 Seires - Page 632

Advanced Guide
>
Faxing
>
Sending Faxes Using the Operation Panel of the Machine
> Resending Faxes
(Redialing a Busy Number)
F012
Resending Faxes (Redialing a Busy Number)
There are two methods of redialing: Automatic redialing and Manual redialing.
Automatic Redialing
If you send a document and the recipient's line is busy, the machine will redial the number after a
specified interval.
Automatic Redialing
Manual Redialing
You can redial to the recipients dialed using the Numeric buttons.
Manual Redialing
Important
It may be possible that faxes will reach unintended recipients due to the misdialing or incorrect
registration of fax/telephone numbers. When you send important documents, it is recommended
that you send them after speaking on the telephone. For details, see Sending a Fax after Speaking
on Telephone
.
Note
Automatic redialing is enabled by default.
Automatic Redialing
You can enable or disable automatic redialing. If you enable automatic redialing, you can specify
the maximum number of redial attempts and the length of time the machine waits between redial
attempts.
Enable and specify the automatic redialing setting on Auto redial in Advanced FAX settings under
Fax settings.
Advanced FAX settings
Important
While automatic redialing, the unsent fax is stored in the machine's memory temporarily until
the sending fax is complete. If a power failure occurs or you unplug the power cord before
automatic redialing is complete, all faxes stored in the machine's memory are deleted and
not sent.
Note
To cancel automatic redialing, wait until the machine starts redialing, then press the
Stop
button.
To cancel automatic redialing, delete the unsent fax from the machine's memory while the
machine is on-standby for a redial operation. For details, see Deleting a Document in
Machine's Memory
.
Manual Redialing
Follow the procedure below for manual redialing.
1.
Make sure that the machine is turned on.
2.
Press the
FAX
button.
The Fax standby screen is displayed.
3.
Load documents on the Platen Glass or in the ADF.
4.
Adjust the scan contrast and resolution as necessary.
Seite 632 von 922 SeitenResending Faxes (Redialing a Busy Number)