Using the Rotary Pulse Line
Dialing by Using the
Hook
Button
Note
You can use the
Hook
button only when Hook key setting in Security control under Fax
settings is set to Enable.
Security control
1.
Make sure that the machine is turned on.
2.
Press the
FAX
button.
The Fax standby screen is displayed.
3.
Press the
Hook
button.
4.
Use the Numeric buttons to dial the number of the information service.
5.
When the recorded message for the information service answers, press the
Tone
button to switch to tone dialing.
6.
Use the Numeric buttons to press the numbers in accordance with the message.
7.
Press the
Hook button to finish using the service.
Dialing by Using the Telephone Connected to the Machine
1.
Make sure that the machine is turned on.
2.
Press the
FAX
button.
The Fax standby screen is displayed.
3.
Lift the handset of the telephone.
4.
Use the telephone to dial the number of the information service.
5.
When the recorded message for the information service answers, use the telephone
to switch to tone dialing.
When you dial the number of the information service using the telephone connected to
the machine, you cannot use the machine to switch to tone dialing. For instructions on
how to switch to tone dialing, refer to your telephone's instruction manual.
6.
Use the telephone to press the numbers in accordance with the message.
7.
Hang up the handset to finish using the service.
Page top
Seite 679 von 922 SeitenUsing the Information Services
To Next Page
Loading...
