you are using.
Preparing for Faxing
Memory is full
The machine's memory is full because it has
sent/received too many documents, or a
detailed document.
When sending a fax, divide it to resend.
When receiving a fax, print the received faxes
stored in machine's memory or save them on
the USB flash drive, delete them from the
machine's memory, and have the sender
resend the faxes.
Document Stored in Machine's Memory
Awaiting doc. processing.
(MX410 series)
The received faxes were not saved on the USB
flash drive automatically because the USB flash
drive was not inserted or because it was not
Press the
OK
button.
The received faxes are stored in machine's
memory. Insert the writable USB flash drive, then
save the received faxes to the USB flash drive
manually.
Saving a Document in Machine's Memory to
USB Flash Drive
Delete the unnecessary fax from machine's
memory after saving to the USB flash drive.
Deleting a Document in Machine's Memory
Change the paper
A4/LTR/Legal Plain paper
The page size setting is set to a size other than
A4, Letter-, or Legal-size. Set Page size to A4,
Letter, LTR, or Legal and Media type to Plain paper
to print received faxes.
Changing the Print Settings
Note
Some of page sizes are not available
depending on the country or region of
purchase.
Fax info does not match
Transmission has been canceled because the
machine could not detect the recipient's fax
machine information or the information did not
match the dialed number. This message is
displayed when Check RX fax info in Security
control under Fax settings is set to ON.
For details, see
Sending Faxes after Checking
Information (Checking the Recipient's
Information)
.
Reception rejected
Reception has been rejected because the fax
matches the fax rejection condition specified by
Fax reception reject in Security control under Fax
settings.
For details, see
Rejecting Fax Reception
.
Waiting for report
If the machine receives a fax under one of the
following conditions, the machine will not be able
to print the reports. When the problem is resolved
as described, the reports are printed
automatically.
The amount of remaining ink is insufficient to
print a report:
Replace the FINE Cartridge.
Routine Maintenance
Paper has run out:
Seite 807 von 922 SeitenA Message for Faxing Is Displayed on the LCD
To Next Page
Loading...
