D-Link xStack DGS-3420 Series - Page 122

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
117
Parameters
<range_name 32> - Specify the name of the time range settings.
hours start_time - Specify the starting time in a day. (24-hr time). For example, 19:00 means 7PM.
19 is also acceptable. The start_time must be smaller than the end_time.
< hh:mm:ss> - Specify the time.
end_time - Specify the ending time in a day. (24-hr time)
< hh:mm:ss> - Specify the time.
weekdays - Specify the list of days contained in the time range. Use a dash to define a period of
days. Use a comma to separate specific days. For example, mon-fri (Monday to Friday)
sun, mon, fri (Sunday, Monday, and Friday)
<daylist> - Specify a list of days.
delete - Delete a time range profile. When a time range profile has been associated with ACL entries,
the deletion of this time range profile will fail.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the range of time to activate a function on the switch:
DGS-3420-28SC:admin#config time_range testdaily hours start_time 12:0:0 end_time
13:0:0 weekdays mon,fri
Command: config time_range testdaily hours start_time 12:0:0 end_time 13:0:0
weekdays mon,fri
Success.
DGS-3420-28SC:admin#
5-6 show time_range
Description
This command is used to display current time range settings.
Format
show time_range
Parameters
None.
Restrictions
None.