D-Link xStack DGS-3420 Series - Page 149

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
144
Rule ID : 2 (auto assign) Port group: 1
Match on
Source IP : 10.0.0.1
Destination IP : 10.90.90.90
DSCP : 25
Action:
Permit
Matched Count : 0 packets
================================================================================
DGS-3420-28SC:admin#
The following example displays an egress access profile that supports an entry mask for each rule:
DGS-3420-28SC:admin# show egress_access_profile profile_id 1
Command: show egress_access_profile profile_id 1
Egress Access Profile Table
================================================================================
Profile ID: 1 Profile name: 1 Type: Ethernet
Mask on
Source MAC : FF-FF-FF-FF-FF-FF
Available Hardware Entries : 127
--------------------------------------------------------------------------------
Rule ID : 1 Port group: -
Match on
VLAN ID : 1
Source MAC : 00-00-00-00-00-01
Action:
Permit
================================================================================
DGS-3420-28SC:admin#
6-5 show current_config egress_access_profile
Description
This command is used to display the egress ACL part of current configuration in user level of privilege.