D-Link xStack DGS-3420 Series - Page 150

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
145
The overall current configuration can be displayed by “show config” command which is accessible in
administrator level of privilege.
Format
show current_config egress_access_profile
Parameters
None.
Restrictions
None.
Example
To display current configuration of egress access list table:
DGS-3420-28SC:admin# show current_config egress_access_profile
Command: show current_config egress_access_profile
#-------------------------------------------------------------------------------
# Egress ACL
create egress_access_profile profile_id 1 profile_name 1 ethernet source_mac FF-
FF-FF-FF-FF-FF
config egress_access_profile profile_id 1 add access_id 1 ethernet source_mac 00
-00-00-00-00-01 vlan_based vlan_id 1 permit
create egress_access_profile profile_id 2 profile_name 2 ip source_ip_mask 255.2
55.255.255 destination_ip_mask 255.255.255.255 dscp
config egress_access_profile profile_id 2 add access_id auto_assign ip source_ip
10.0.0.2 destination_ip 10.90.90.90 dscp 25 port_group id 1 permit counter enable
config egress_access_profile profile_id 2 add access_id auto_assign ip source_ip
10.0.0.1 destination_ip 10.90.90.90 dscp 25 port_group id 1 permit
#-------------------------------------------------------------------------------
DGS-3420-28SC:admin#
6-6 config egress_flow_meter
Description
This command is used to configure the packet flow-based metering based on an egress access profile
and rule.