D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
304
Format
delete dhcp pool [<pool_name 12> | all]
Parameters
<pool_name 12> - Specify the name of the DHCP pool.
all - Specify to delete all the DHCP pools.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a DHCP pool:
DGS-3420-28SC:admin#delete dhcp pool nyknicks
Command: delete dhcp pool nyknicks
Success.
DGS-3420-28SC:admin#
22-6 config dhcp pool network_addr
Description
This command is used to specify the network for the DHCP pool. The addresses in the network are
free to be assigned to the DHCP client. The prefix length specifies the number of bits that comprise
the address prefix. The prefix is an alternative way of specifying the network mask of the client. The
prefix length must be preceded by a forward slash (/). When the DHCP server receives a request from
the client, the server will automatically find a pool to allocate the address. If the request is relayed to
the server by the intermediate device, the server will match the gateway IP address carried in the
packet against the network of each DHCP pool. The pool which has the longest match will be selected.
If the request packet is not through relay, then the server will match the IP address of the IPIF that
received the request packet against the network of each DHCP pool.
Format
config dhcp pool network_addr <pool_name 12> <network_address>
Parameters
<pool_name 12> - Specify the DHCP pool name.
<network_address> - Specify the IP address that the DHCP server may assign to clients.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English