D-Link xStack DGS-3420 Series - Page 367

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
362
DGS-3420-28SC:admin# show dhcpv6_server
Command: show dhcpv6_server
DHCPv6 Server Global State: Disabled
---------------------------------------------------------------
IP Interface : System
DHCPv6 Server State : Enabled
IP Interface : ipif1
DHCPv6 Server State : Enabled
Total Entries : 2
DGS-3420-28SC:admin#
25-16 config dhcpv6 pool excluded_address
Description
This command is used to configure the reserved IPv6 addresses on the DHCPv6 server.
Format
config dhcpv6 pool excluded_address <pool_name 12> [add begin <ipv6addr> end <ipv6addr>
| delete [begin <ipv6addr> end <ipv6addr> | all]]
Parameters
<pool_name 12> - Enter the DHCPv6 pool name used here. This name can be up to 12
characters long.
add - Specifies to add an excluded address range for a specified pool.
begin - Specifies the beginning IPv6 address of the range of IPv6 addresses to be excluded
from the DHCPv6 pool.
<ipv6addr> - Enter the beginning IPv6 address used here.
end - Specifies the ending IPv6 address of the range of IPv6 addresses to be excluded from
the DHCPv6 pool.
<ipv6addr> - Enter the ending IPv6 address used here.
delete - Specifies to delete one or all excluded address ranges of a specified pool.
begin - Specifies the beginning IPv6 address of the range of IPv6 addresses to be excluded
from the DHCPv6 pool.
<ipv6addr> - Enter the beginning IPv6 address used here.
end - Specifies the ending IPv6 address of the range of IPv6 addresses to be excluded from
the DHCPv6 pool.
<ipv6addr> - Enter the ending IPv6 address used here.
all - Specifies to delete all excluded address ranges of a specified pool.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.