D-Link xStack DGS-3420 Series - Page 574

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
569
Parameters
ports - Specify a range of ports to configure the multicast address filtering function.
<portlist> - Specify a range of ports to be configured.
vlanid - Specify the VLAN ID of the VLAN that the multicast address filtering function will be
configured on.
<vlanid_list> - Enter the VLAN ID of the VLAN that the multicast address filtering functions will be
configured on here.
ipv4 - (Optional) Specify the IPv4 multicast profile.
ipv6 - (Optional) Specify the IPv6 multicast profile.
add - (Optional) Add a multicast address profile to a port or VLAN.
profile_id - (Optional) Specify a profile ID to be added to the port or VLAN.
<value 1-60> - The profile ID must be between 1 and 60.
profile_name - (Optional) Specify a profile name to be added to the port or VLAN.
<name 32> - The profile name can be up to 32 characters long.
delete - (Optional) Delete a multicast address profile from a port or VLAN.
profile_id - (Optional) Specify a profile ID to be deleted from the port or VLAN.
<value 1-60> - The profile ID must be between 1 and 60.
profile_name - (Optional) Specify a profile name to be deleted from the port or VLAN.
<name 32> - The profile name can be up to 32 characters long.
access - (Optional) Specify whether the access is permit or deny.
permit - Specify that the packets that match the addresses defined in the profiles will be
permitted.
deny - Specify that the packets that match the addresses defined in the profiles will be denied.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add multicast address profile 2 to ports 1 and 3:
DGS-3420-28SC:admin#config limited_multicast_addr ports 1,3 add profile_id 2
Command: config limited_multicast_addr ports 1,3 add profile_id 2
Success.
DGS-3420-28SC:admin#
49-7 show limited_multicast_addr
Description
This command is used to display a multicast address range by ports or by VLANs. When the function
is configured on a port or VLAN, it limits the multicast group operated by the IGMP/MLD snooping
function and layer 3 function. If the IPv4 or IPv6 option is not specified, IPv4 is implied.