D-Link xStack DGS-3420 Series - Page 666

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
661
58-16 show mld_snooping group
Description
This command is used to display the current MLD snooping group information on the switch.
Format
show mld_snooping group {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports <portlist>]
{<ipv6addr>}} {data_driven}
Parameters
vlan - (Optional) Specify the name of the VLAN for which to view MLD snooping group
information. If VLAN and ports and IP address are not specified, the system will display all
current MLD snooping group information.
<vlan_name 32> - Specify the VLAN name. The maximum length is 32 characters.
vlanid - (Optional) Specify the ID of the VLAN for which to view MLD snooping group information.
<vlanid_list> - Specify the VLAN ID list.
ports - (Optional) Specify the list of port for which to view MLD snooping group information.
<portlist> - Specify a range of ports to be displayed.
<ipv6addr> - (Optional) Specify the group IPv6 address for which to view MLD snooping group
information.
data_driven - (Optional) Specifies that data driven groups will be included in the display.
Restrictions
None.
Example
To display the MLD snooping group: