Front and rear mudguard
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_5_4.22.1.html[11/12/2015 18:40:17]
Engage ABS sensor cable (B) in its inner fastener (D) on front mudguard (1) and refit dust seal (C).
Position the front mudguard (1) and start the special screws (5), using the recommended threadlocker.
Insert brake rubber block (A) into grommet (4) and ensure it is centred.
Fold the grommet (4), secure it by starting and tightening the screw (9) to a torque of 0.4 Nm ±10% (Sect. 3 - 3,
Frame
torque settings).
Tighten the screws (5) to a torque of 5 Nm ±10% (Sect. 3 - 3, Frame torque settings).
It is necessary to check the air-gap between the speed sensor (F) and the phonic wheel (G).
For this purpose, use a feeler gauge (A) to check the air-gap; then, carry out 4 measures of the air-gap, one every 90° of
wheel turn.
Phonic wheel sensor AIR GAP range is 1.3 mm to 1.9 mm.
To Next Page