ABS components maintenance
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_7.44.1.html[11/12/2015 18:40:32]
Bleeding of the ABS hydraulic system
If some “sponginess” is detected on the brake control, due to air bubbles in the system, bleed the system, as indicated in
Sect. 4 - 3,
Changing the brake fluid.
Before bleeding a brake master cylinder, move back the calliper pistons, as indicated in (Sect. 4 - 3,
Filling the brake
system with fluid) to drain in the pump the air collected near the ABS control unit
Bleeding must be carried out by means of the corresponding joints (1) placed near the callipers and the brake cylinders.
Important
Do not undo the fixing screws of the joints of the pipes on the ABS hydraulic control unit, unless control unit replacement
is necessary.
Important
If the ABS control unit is replaced, this must be supplied with secondary circuit already full of fluid; the control unit must
be fitted and the system filled and bled as a traditional system.
To Next Page
Loading...
