Fuel tank
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_8_2.58.1.html[11/12/2015 18:40:39]
Position seal (32) in tank cap (2) as shown and reassemble following the removal procedure in the reverse sequence.
In particular tighten the screws (3) to a tightening torque of 3 Nm ±10% (Sect. 3 - 3, Frame torque settings).
Removal of the fuel tank flange
Unscrew the screws (28) and (22) securing the fuel tank flange (23).
Remove the flange (23) from the tank.
Recover the O-ring (24).
Using the appropriate commercial tool, undo the clips (26) next to the fuel filter (25).
Remove the old filter from the connecting hoses and fit a new filter.
Before reassembly, carefully remove any deposits or scale from all parts.
Important
When installing the filter (25), position it so that the arrow on the external housing is pointing towards the flange.
Note
The flange is supplied as a spare part complete with the fuel pump and pressure regulator: the entire flange assembly
must be replaced in the event of malfunction.
To Next Page