Ducati Monster 796 - Disassembly of the Gearchange Control; Refitting the Gearchange Mechanism

Gearchange mechanism
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_9.47.1.html[11/12/2015 18:40:33]
seals (17).
Unscrew and remove the clamp screw (16) securing the gearchange lever (14) to the gear selector shaft.
Withdraw the lever (14) complete with the gearchange control assembly.
Note
Mark the position of lever (14) relative to the gear selector shaft.
To remove the lever (14) from the gearchange assembly, remove the bolt (15).
Disassembly of the gearchange control
Refer to the exploded view at the beginning of this section for indications on disassembly and renewal of gearchange
components.
If the bush (5) inside the pedal (2) needs replacing, drive the new bush into place using a press. The bush must be seated
2 mm below the outer face of the pedal.
Warning
After working on the gearchange mechanism, check the position of the gear pedal.
To adjust the gearchange pedal position, follow the instructions indicated in Sect. 4 - 3,
Adjusting the position of the gear
change and rear brake pedals.
Refitting the gearchange mechanism
To refit the gearchange control, reverse the operations of the removal procedure.
Note
Fit new O-rings (17) on each reassembly.