Ducati Monster 796 - Refitting the Front Forks

Fork - steering head: front fork
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_10A.48.1.html[11/12/2015 18:40:34]
Refitting the front forks
Refit the fork legs, positioning them at the height shown in the figure relative to the upper surface of the bottom yoke.
Position the legs (2) and (1). If they were removed, grease the thread and the underside of the screws (24) and (25) and
place them in their seats.
Tighten the screws (24) to a torque of 24 Nm ±5% and the screws (25) to a torque of 22 Nm ±5% (Sect. 3 - 3,
Frame
torque settings) in the sequence 1-2-1.
Warning
Do not use the motorcycle without the front mudguard fitted to avoid the risk of the brake pipes fouling the wheel on
braking.
Operations Section reference
Refitting the front wheel 7 - 1,
Refitting the front wheel
Refitting the front mudguard 5 - 4,
Refitting the rear mudguard
Refitting the front brake callipers 7 - 3,
Refitting the front brake
system
Refitting the front ABS sensor 7 - 6,
Replacing the front phonic
wheel sensor