Fork - steering head: Steering
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_10B.49.1.html[11/12/2015 18:40:34]
HEADLIGHT
796 ABS
HANDLEBAR AND CONTROLS
796 ABS
HEADLIGHT
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in
the exploded view diagram.
Adjusting the steering head bearings
Note
To adjust the steering bearing clearance, follow what is described in Sect. 4 - 3, Adjusting the steering head bearings.
If the problems found are not solved, check the wear of steering bearings (5) and (6) and replace them, if necessary, as
described in paragraph “
Removal of the steering head components” of this section.
Steering angle adjustment
Loosen the nuts (17) and adjuster screws (16) on both sides of the bottom yoke.
Use a 6 to 6.5 mm spacer (A) fitted to the fork outer tube, or use a gauge.
To Next Page
Loading...
