Rear wheel
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_2.39.1.html[11/12/2015 18:40:29]
Remove the rear wheel from the motorcycle.
Overhauling the rear wheel
Inspect the condition of the rear wheel.
As the rear wheel has no bearings, it should be supported on the service tool part no. 88713.1073.
Note
This service tool can also be used to install the wheel on a balancing machine.
Overhauling the wheel
Inspect the wheel as follows:
Visually inspect the wheel for cracks, scoring and deformation; change the wheel if damaged.
Fit the wheel on service tool no. 88713.1073 using the original fasteners.
Using a dial gauge, appropriately supported, measure wheel rim runout and out-of-round according to the wheel shaft
(Sect. 3 - 1.1,
Rear wheel).
If the values measured are not within the tolerance limits, renew the wheel.
To Next Page