Gearbox assembly: gearchange mechanism
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_9_7A.75.1.html[11/12/2015 18:40:50]
Apply grease and then fit the ball (8), the spring (7), and the seal (6) into the interlock plunger (5) and tighten the
interlock plunger assembly into the crankcase.
Tighten the interlock plunger to a torque of 30 Nm (Min. 27 Nm - Max. 33 Nm) (Sect. 3 - 3,
Engine torque settings) and
screw in the interlock plunger into the crankcase.
Operations Section reference
Refit the clutch drum 9 - 6.3, Refitting the primary drive
gears and checking backlash
Refit the complete clutch
assembly
9 - 6.1,
Refitting the APTC clutch
Refit the clutch cover 9 - 6.2,
Refitting the clutch cover
Connect the oil pressure sensor 6 - 5,
Checking the indicating devices
Refill the engine with oil 4 - 3,
Changing the engine oil and
filter cartridge
Refitting the gear selector lever
Position the gearbox drum selector fork in the centre of the gear rollers.
Position the whole gear selector lever (21) into the chain-side crankcase half.
To Next Page