Handlebar unit: Throttle twistgrip
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_8A.45.1.html[11/12/2015 18:40:32]
Refit the right-hand and left-hand
handlebar switches
6 - 5, Checking the indicating
devices
Refit the throttle twistgrip 7 - 8.1,
Refitting the throttle
twistgrip
Refit the clutch lever 7 - 8.2,
Refitting the clutch master
cylinder assembly
Adjusting the throttle cable
To operate on the set screws of the throttle grip cables, consult Sect. 4 - 3, Adjusting the throttle cable.
Removal of the throttle twistgrip
Turn throttle control pulley so as to disengage cable stop pin (A) from pulley.
Raise gaiter (B), loosen lock nut (C) and adjuster (12) until sliding it off the throttle control pulley on throttle body.
Loosen and remove the screws (8) and the cover (7), then disconnect the throttle cable from the throttle control, by
sliding off the cable stop pin (D) from the pulley and loosening adjuster (11) until removing it.
To Next Page
Loading...
