Ducati Monster 796 - Flexible Wiring;Hoses Positioning

System components
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_6.43.1.html[11/12/2015 18:40:31]
To fill up the system, carry out the instructions for replacement of fluid of the pump or calliper to which the pipe is
connected (Sect. 4 - 3,
Filling the brake system with fluid).
Important
If the ABS control unit is replaced, this must be supplied with secondary circuit already full of fluid; the control unit must
be fitted and the system filled and bled as a traditional system.
Operations Section reference
Refit the fuel tank 8 - 2,
Refitting the fuel tank
Refit the seat 5 - 3,
Refitting the seat
Flexible wiring/hoses positioning
The routing of the ABS wiring has been optimised to ensure the minimum obstruction.
Each section is designed to prevent interference with parts that might damage wires or cause operating failures when
riding.
Table Position Description
Table E - Table F 2 ABS / speed sensor (Front)
Table C - Table D 5 Speed sensor / ABS (Rear)
Table A 6 ABS control unit
Table A - Table E 7 Front pump - control unit pipe
Table A - Table E 8 Control unit - front calliper pipe
Table A - Table B - Table D 9 Rear pump - control unit pipe
Table A - Table B - Table C 10 Control unit - rear calliper pipe
Table C - Table E - Table F 19 Hose clip
Table E - Table F 21 Front brake hose
Table A