Clutch assembly: APTC wet clutch
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_9_6A.72.1.html[11/12/2015 18:40:48]
Overhaul and inspection of the APTC clutch components
Clearance between the clutch drum and friction plates
Insert a friction plate (C) in the clutch drum (A) and measure the clearance (S) with a feeler gauge.
Clearance “S” must not exceed 0.6 mm.
If it does, renew the plates and, if necessary, the clutch drum.
Overhaul of the clutch plates
The clutch plates must not show any signs of blackening, grooves or deformation.
Measure the thickness of the friction plates. It should not be less than 3.2 mm.
Important
The total thickness of the clutch plate pack must not be less than 50.2 mm.
To Next Page