Maintenance operations
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_4_3.17.1.html[11/12/2015 18:40:14]
Checking valve clearances
In order to check the valve clearances, it is necessary to gain access to the four valve covers on the cylinder heads and
then remove the parts listed below.
Open the lock and simultaneously apply downward pressure in the area of the catch to release the pin; Pull the seat
backwards to release it from the front catches and remove it.
Remove the tank covers (Sect. 5 - 2, Removal of the fuel tank fairings).
Unscrew the side screw (1) securing tank to the frame and recover the washer (2).
Unscrew the rear screw (3) securing tank and recover the washer (4).
Raise the tank but leave it connected to the fuel system and wiring then position it on the side, duly supported, to be able
to work on the valve covers (5) of the vertical head.
Note
In the ABS version loosen and remove the two retaining screws (A) and the bracket (B).
To Next Page
Loading...
