Diagnostic instruments
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_6_13.36.1.html[11/12/2015 18:40:27]
On completion of the operation, the message “Was the operation completed successfully?” will appear; press
“Confirm” (B).
If any problems were encountered during the operation, the tester will display the relative error messages: each message
must be confirmed (by pressing the “Confirm” icon (B)), or rejected (by pressing the “Exit” icon (C)).
Once the reset has been performed, the ECU will be associated with the motorcycle’s throttle body. Replacement of the
throttle body, the throttle position sensor or the ECU must always be immediately followed by a new reset procedure.
Adjusting the idle speed
Note
Check that the motorcycle is fitted with a genuine Ducati ECU, intake system and exhaust system; if not, fit genuine
components.
Connect the inserts of the exhaust gas analyser code 88713.1010 to the outlets on the exhaust pipes, using the fittings
(1).
To Next Page
Loading...
