Rear brake control
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_4.41.1.html[11/12/2015 18:40:30]
Fit the rear brake control rod on the pivot bolt (9), securing it with the clip (11).
Now lubricate the other end of the pushrod (19) with the recommended grease and insert it in the master cylinder (1).
Refit the clamp (C).
Set the washer in-between the RH footrest bracket and the frame.
Fasten the right-hand side footrest bracket to the swinging arm using the screw (A), duly lubricated, and to engine using
screws (B). Tighten the screws (A) to a torque of 55 Nm ± 5% and the screws (B) to a torque of 36 Nm ±10% (Sect. 3 -
3,
Frame torque settings) in the mentioned sequence.
Operations Section reference
Fill the brake circuit 4 - 3, Filling the brake system with
fluid
Removal of the rear brake calliper
To Next Page