Fork - steering head: front fork
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_7_10A.48.1.html[11/12/2015 18:40:34]
This distance should be 81 mm.
Clean off any oil from spring (9) and spring retainer (12) before assembly.
Note
Install the spring (9), ensuring that the end with tighter coils is towards the bottom of the fork.
Fit the following components:
-spring (9);
-spring retainer (12).
Fit service tool part no. 88713.0957 (previously used for removal) into the lateral hole of the spring retainer (12).
Press tool down and set spacer (C) under the cartridge (8) lock nut.
Remove service tool no. 88713.0958.
Screw the top cap (7) onto the damper (8).
Using a hexagon wrench, hold the rebound damping adjuster and tighten the top cap to 30 to 40 Nm.
Remove the spacer (C) by pushing the tool part no. 88713.0957 downwards.
Warning
The adjuster on the top cap (7) should be screwed fully onto the thread of the damper (8).
Lift the outer tube (18) and tighten the top cap (7) to a torque of 30 to 40 Nm.
Set the adjusters according to riding requirements.
To Next Page