Cylinder/piston assemblies
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_9_5.71.1.html[11/12/2015 18:40:47]
oil). Position the cylinder with the smallest valve pockets facing the exhaust port.
Remove any deposits and degrease the contact surfaces of the crankcase half and the cylinders.
Check that pin (1) is installed on the crankcase.
Apply a bead of liquid gasket to the mating surfaces of gasket (6):
the exact configuration of the bead of liquid gasket varies according to whether the gasket is for the (6) for the vertical
cylinder (V) and the horizontal cylinder (O). The picture shows liquid gasket application surfaces for the various
configurations.
Surface in contact with the vertical cylinder (A).
Surface in contact with the crankcase, at the vertical cylinder (B).
Surface in contact with the horizontal cylinder (C).
Surface in contact with the crankcase, at the horizontal cylinder (D).
Locate the gasket (6) on the crankcase with the word “TOP” facing upwards.
To Next Page