Crankcase assembly: crankcase halves
file:///D|/Manuales/Para%20recolocar/MOTOS/DUCATI/DUCATI/M796/wsm/EN/M796_ABS_11_9_9B.79.1.html[11/12/2015 18:40:53]
At each overhaul it is recommended to renew also the oil sealing ring (11) on the outside of bearing (10) as well as oil
sealing ring (20) on the outside of bearing (21).
In the event of renewal of needle roller bearings (27) and oil seals (28) on the swingarm pivot, lubricate the seats of the
bearings and the lips of the oil seals with the recommended grease.
Install the inner sealing ring (28) as shown in figure (E) and seated against the circlip (29); the outer oil seal must also be
installed as shown in figure (E).
Use a suitable drift (see figure) to install the oil seals (28) and roller bearings (27).
Check that the oilways are free of restrictions or clogging.
The bearings (27) are to be installed with writing (F) oriented as shown in the figure
To Next Page
Loading...
