Chapter 5
| SNMP Commands
– 160 –
show snmp engine-id Shows the SNMP engine ID PE
show snmp group Shows the SNMP groups PE
show snmp user Shows the SNMP users PE
show snmp view Shows the SNMP views PE
Notification Log Commands
nlm Enables the specified notification log GC
snmp-server notify-filter Creates a notification log and specifies the target host GC
show nlm oper-status Shows operation status of configured notification logs PE
show snmp notify-filter Displays the configured notification logs PE
ATC Trap Commands
snmp-server enable port-
traps atc broadcast-alarm-
clear
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been
triggered
IC (Port)
snmp-server enable port-
traps atc broadcast-alarm-
fire
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc broadcast-control-
apply
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port)
snmp-server enable port-
traps atc broadcast-control-
release
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been
triggered and the release timer expires
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
clear
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
fire
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc multicast-control-
apply
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port)
snmp-server enable port-
traps atc multicast-control-
release
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered and the release timer expires
IC (Port)
Transceiver Power Threshold Trap Commands
transceiver-threshold
current
Sends a trap when the transceiver current falls outside the
specified thresholds
IC (Port)
transceiver-threshold
rx-power
Sends a trap when the power level of the received signal
falls outside the specified thresholds
IC (Port)
transceiver-threshold
temperature
Sends a trap when the transceiver temperature falls
outside the specified thresholds
IC (Port)
transceiver-threshold
tx-power
Sends a trap when the power level of the transmitted signal
power outside the specified thresholds
IC (Port)
transceiver-threshold
voltage
Sends a trap when the transceiver voltage falls outside the
specified thresholds
IC (Port)
Table 28: SNMP Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General