EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Summary 116
Figure 4-1. Directional View of the Printer
C A U T I O N
Before servicing or performing maintenance on the printer,
make sure you have enough space. If you need to move the
printer, be sure the space you move to is safe.
Because the printer is much heavier than most printers (about
132Kg with stand), you need to take extra care. If you need to
take apart the printer and stand or lift the printer, four persons
are necessary.
Ink may leak onto other printer parts or the printer basket when
removing printer parts, so it is recommended to put a sheet or
cloth under the printer, especially when working on or near ink-
related parts.
When working on the electrical circuit boards, be careful
concerning static electricity which can cause damage to the
board. It is recommended you use an anti-static wrist band or
similar grounding device to prevent static electricity buildup.
Use caution to avoid injury from contact with internal high-speed
components such as the carriage fan when it is necessary to allow
printer operation with any cover removed.
Use caution to avoid injury from the unusually sharp steel belt
and cutter blade used with the carriage drive.
Use caution to avoid bumping the cutter blade into other printer
metal components because an extremely hard edge is used for the
cutter blade and it has unusually fragile properties.
C H E C K
P O I N T
If you find it is necessary to perform service on a part not
described in this chapter, be sure to check the after-service parts
situation before beginning the service.
If necessary (i.e. when transporting the printer) use the above
mentioned mode to drain ink, install the discharge cartridges
(Stylus Pro 10000/10000CF: P/N1060626, Stylus Pro 10600: P/
N1214261), and then perform an initial ink charge with the fluid.
Enter the transportation mode again to remove the fluid (user
can do) and then perform initial ink charge with ink.
The directional instructions in this chapter are given as if viewing
the printer from the front. See the illustration below.
Top
Bottom
Rear
Front
R
L
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
