Epson Stylus Pro 10000 - Gap Adjustment

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Product Description SelecType Settings 44
1.6.6 Gap Adjustment
This mode is used to perform each of the adjustment items (paper thickness, Bi-D
adjustment 1, Bi-D adjustment 2) as shown in the table below.
<Setup>
1. Set the paper in place.
2. Select the gap adjustment menu from the panel.
3. Set to ’STD’ when using EPSON paper (0.2mm or 1.2mm thick). For other paper,
set thickness in units of 0.1mm.
4. Select the adjustment pattern to be printed (all or individual), and print.
5. Check the printed adjustment patterns and enter the number of the pattern with the
least displacement for each adjustment item.
6. Repeat (4)~(5) until adjustment of all items is complete.
Figure 1-11. Gap Ajustment print pattern
Figure 1-12. Gap Ajustment print pattern
<Adjustment>
Adjustment values set by the adjustments shown above are saved in NVRAM. The
purpose of preserving paper thickness (at time of adjustment) is for the thickness value
of the paper thickness setting command PH corrected by units of 0.1mm.
Table 1-43 shown the gap ajustment menu.
NOTE: (*1) When Standard paper is selected the following paper is selected as
a result the of detection of paper thickness.
0.2mm if the paper thickness sensor detects thin paper.
1.2mm if the paper thickness sensor detects thick paper.
NOTE: (*2) Paper thickness is inputted at first to print a pattern close to last
setting, then it reduce repetition of operation.
NOTE: (*3) It displays "PAT. PRINTING" during printing pattern.
Table 1-43. Gap Ajustment Menu
Display Messages Item Notes
PAPER THICK
STD
0.0~1.6mm*1, *2
Select the thickness, to 0.1mm, of the paper you
are using to check the platen gap. Normally,
leave set to Standard.
ADJUST. PATT.
All
#1, #2
KCMY*3
Selects which patterns to print. (All patterns or
selected patterns only.)
#1 1~8~15
Bi-D adjustment 1 (240cps, VSD1, Small)
#2 1~8~15
Bi-D adjustment 2 (300/240cps, VSD2, Large)
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com