Epson Stylus Pro 10000 - H Top Cover Removal

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 122
4.3.1.3 H Top Cover Removal
1. Open Front Cover and Roll Paper Cover.
2. Remove top side four screws (CS: M4x8), then remove front side two screws (CS:
M4x8).
Figure 4-11.
3. Remove the H Top Cover by pulling up and toward the front.
Top side
four screws
Front two
screws
Screws
Front View
Top View
C A U T I O N
Make sure the left and right grounding plates do not get bent
during the disassembly / assembly process.
Figure 4-12.
grounding plates
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com