Epson Stylus Pro 10000 - Removing Dot Missing Detector

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 172
4.3.3.15 Removing Dot Missing Detector
1. Remove the Flushing Box as described in 4.3.3.14 "Removing Flushing Box".
2. Use a finger to grasp the rear side of the Ink Pump Assy and lift it in the direction
of the arrow. Release the carriage lock and move Carriage from the home position.
Figure 4-136. Release the Carriage Lock
3. Remove the Rear Cover as described in 4.3.1.7 "Rear Cover Removal".
4. Disconnect the connector connected to CN17 and CN18 on the C362DRV Board,
then remove it from the hole in the R Side Frame.
Figure 4-137.
W A R N I N G
Use caution when handling this unit because it contains laser
generating elements. Read cautions listed in Preface. The label
shown below is attached to the unit. Laser emitted from window
shown in photo below.
Figure 4-135.
A D J U S T M E N T
R E Q U I R E D
In the case that removed or exchanged the Dot missing detector,
carry out the dot missing offset adjustment.
Window
Dot missing
detector
Cables
(connected to
CN17 and CN18
on the C362DRV
board)
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com