Epson Stylus Pro 10000 - Adjustment

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Self-Diagnostics 220
1. Shutter
Change the shutter position with panel operation.
Figure 5-33 showing shutter menu.
Figure 5-33.
2. Cutter
Up and Down the cutter with panel operation.
Figure 5-34 showing cutter menu.
Figure 5-34.

"Paper feed -" key is inactivated during the "Cutter Up "display.
 "Paper feed+-" key is inactivated during the "Cutter Down "display.
 If the "Cutter Down" condition continues for 60 seconds, it automatically goes to
"Cutter Up."
5.4.4 Adjustment
Perform the mechanical adjustment (Head slant) and firmware parameter adjustment.
All of adjustment items are adjusted at the factory. Head cleaning with wash I/C
cartridge, head rank input, ink charge and print position adjustment are necessary when
print head is replaced. CW and Bi-D adjustment is required when the miss alignment
occur with print position, because of platen height change. Paper feeding adjustment
(Refer to described on paragraph 5.2.3.11) is necessary when the paper feed
differences.
Table 5-10 showing adjustment items.
Capping and flushing position adjustment is not required even if the related adjustment
menu appear during the adjustment.
Shutter : Close
Shutter : Close
Shutter : Open
Paper Feed -
Paper Feed -
Paper Feed -
Paper Feed -
Paper Feed +
Paper Feed -
Paper Feed -
Paper Feed -
Cutter : Up
Cutter : Down
Paper Feed +
Paper Feed -
Table 5-10.
Item Description
Skew adjustment Perform the paper feeding and detect the skew with sensor.
Head rank input
Input the characteristic of print head.(Data is indicated on the
head.)perform the ink charge after the input.
Head nozzle check Ensure the condition with test print.
Dot missing offset
adjustment
Input the offset value.
Dot missing detector Print the result of dot missing.
A13 slant adjustment Check the head slant with sample.(Mechanical adjustment)
A123 slant adjustment Check the head slant with sample.(Mechanical adjustment)
B123 slant adjustment Check the head slant with sample.(Mechanical adjustment)
Bi-D adjustment Adjust the position with Bi-D printing.
Head LR adjustment Adjust the position with Uni-D printing.
paper feeding adjustment Correct the paper feed according to the paper type.
Top and bottom
adjustment
Set the top and bottom margin.
Rear sensor position Adjust the position by using cut sheet.
Print test pattern Head nozzle, adjustment pattern
Print head Wash Use wash I/C cartridge
Counter clear Clear the various software counter
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com