Epson Stylus Pro 10000 - Error

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Troubleshooting Troubleshooting Using the Error Messages 84
3.2.4 Error
This table explains the error messages and LED indicator conditions that can be
corrected by the user and provides error details and cancellation methods.
NOTE: Only when the panel display of the PG binding is PG setting = Large, the
"H" is displayed to the 20th columns of the liquid crystal devices.
Table 3-4. Panel display
LCD message Status Reference
PAPER OUT Paper End / End of roll Table 3-5 on page 84
LOAD xxx PAPER Difference with roll paper and sheet Table 3-6 on page 85
LOAD PAPER Paper set lever is released Table 3-7 on page 85
PAPER JAM Paper jam Table 3-8 on page 85
FRONT COVER OPEN Cover open Table 3-9 on page 85
PAPER NOT CUT Paper cutting error Table 3-10 on page 86
PAPER NOT STRAIGHT Paper not straight (Skew error) Table 3-11 on page 86
RELOAD PAPER
Paper check error / Paper eject error
(sheet)
Table 3-12 on page 87
RELOAD PAPER Auto take-up reel failed Table 3-13 on page 87
INK COVER OPEN Replacing ink cartridge Table 3-14 on page 87
INK OUT Ink end Table 3-15 on page 88
NO INK CARTRIDGE No ink cartridge Table 3-16 on page 88
OPTION I/F ERROR Type B interface error Table 3-17 on page 88
UNABLE TO PRINT Can not test printing Table 3-18 on page 88
NOZZLE CHECK ERROR Nozzle check error Table 3-19 on page 88
CLOSE INK COVER Ink cover open Table 3-20 on page 89
WRONG CARTRIDGE Wrong ink cartridge (Dye / Pigment) Table 3-21 on page 89
INVALID CARTRIDGE Illegal ink cartridge Table 3-22 on page 89
DEFECTIVE INK CRTG Defective ink cartridge
COMMAND ERROR
Wrong printer driver / COMMAND
error
Table 3-24 on page 89
READY *1 Ready to print -
SERVICE.REQ.nnnnnnnn Fatal error Table 3-25 on page 90
Table 3-5. Paper End/End of roll
Item Description
LCD message PAPER OUT
LED indicator
status
"Paper Out" LED goes on
Explanation
Paper End / End of roll
This error occurs in following cases;
• None of paper set.
• The printer detects end of roll paper. In this time the paper feed roller holds
and keeps the end of roll paper.
• The printer prints out a sheet or detects end of sheet. In this time the paper
feed roller holds and keeps the end of sheet.
Recovery
• Set new paper.
• Remove the paper and set new one.
After setting the new paper, the error is cleared. If data remains, the printing
job will continue in the new paper. When printing job continue, the printer
ejects buffer content, cuts or ejects the paper, and starts printing after
developing new data. Remained data is printed and ejected with paper length
designated with the command.
Table 3-4. Panel display
LCD message Status Reference
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com