Epson Stylus Pro 10000 - Removing the P_REAR Sensor ASSY; Removing the Front Cover Sensor ASSY

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 182
4.3.3.25 Removing the P_REAR Sensor ASSY
1. Remove the Paper Guide U as described in 4.3.1.11 "Removing Paper Guide U".
2. Disconnect the cable for the P_REAR Sensor ASSY from its connector CN44 on
the C362MAIN Board.
3. Remove two screws (CBS: M2x6) securing the P_REAR Sensor, and remove it.
Figure 4-163.
4. Release the harness for the P_Rear Sensor ASSY from the cable clamps.
NOTE: When removing/installing the Paper Guide U, be careful not to mar the
P_REAR Sensor ASSY with the edge of the sensor inspection window.
4.3.3.26 Removing the Front Cover Sensor ASSY
1. Remove the Front Cover as described in 4.3.1.10 "Front Cover Removal".
Figure 4-164.
C A U T I O N
When assembly, 2 places of bosses are combined.
A D J U S T M E N T
R E Q U I R E D
If you replace the P_REAR Sensor ASSY, perform the necessary
adjustment listed in Chapter 5.
Paper Guide U
Paper_Rear sensor
Screws
(Without Paper Guide U)
Front
Cover
Sensor L
Left hinge unit
Right hinge unit
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com