EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 157
4.3.3.5 Reassembling Head Weight Set <Stylus Pro 10600>
1. Install the Head. (Refer to 4.3.3.3 "Replacing the Printhead".)
2. Set the Head Tilt Adjuster to the center position.
Figure 4-98. Head Tilt Adjuster Position
3. Shift Carriage to left end. (Refer to Figure 4-93.)
4. Slide the CR Weight Retainer (Left) down until it touches the CR Base, then slide
it to the left until it touches CR Frame L.
Figure 4-99. CR Weight Retainer (Left)
5. Slide the CR Weight Retainer (Right) down until it touches the CR Base, then
slide it to the right until it touches CR Frame R.
Figure 4-100. CR Weight Retainer (Right)
Steps 1, 2, 7, 10, 11, 13 (underlined steps) are not necessary during
reassembly of the Head Weight Set if the Head is already fastened.
Move Head Tilt Adjuster
to center position
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
