Epson Stylus Pro 10000 - Leds

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Troubleshooting Troubleshooting Using the Error Messages 82
3.2.2 LEDs
Table 3-2. Indicator Display
Indicator Status Condition
Operate
Printer power on and in status other than those
below
On
Printer processing data, or in power OFF sequence. Blink
Fatal error Blink
Reset, timer IC reset/NVRAM clear On
Paper Out
Paper out, end of roll On
Difference with roll paper and sheet On
Paper set lever is released On
Paper is thick for cleaning On
Paper jam error Blink
paper cutting error Blink
Paper not straight Blink
Paper check error Blink
Problem with paper output (sheet) Blink
Fatal error Blink
Reset, timer IC reset/NVRAM clear On
Maintenance call
On for 100ms at
intervals of 5
seconds
Pause
Print ready Off
In SelecType mode Off
During pause Off
During ink drying time Blink
During ink sequence Blink
Other errors Off
Fatal error Blink
Reset, timer IC reset/NVRAM clear On
Ink Out
Out of specified ink
No cartridge for specified ink
Wrong cartridge for specified ink
Illegal cartridge for specified ink
On
Ink level low Blink
Fatal error Blink
Reset, timer IC reset/NVRAM clear On
Paper Source
Selected paper source On
Fatal error Blink
Difference with roll paper and sheet Blink
Reset, timer IC reset/NVRAM clear On
Table 3-2. Indicator Display
Indicator Status Condition
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com