Epson Stylus Pro 10000 - Rear Cover Removal

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 126
4.3.1.7 Rear Cover Removal
1. From the rear, remove four white screws (CPS: M3x12) securing the optional
interface cover, and remove the optional interface cover.
Figure 4-23.
2. Removing one screw (CBS: M3x6) securing the HJFK (Dummy) board, then
extract HJFK (Dummy) board.
Figure 4-24.
3. Remove two white screws (CBS: M4x6) securing the parallel interface, one white
screw (CBS: M3x6) securing the USB interface, one screw securing the serial
interface, four screws securing the option cover 1, 2, and four screws securing the
option 1,2.
Figure 4-25.
4. Remove one screw securing the Battery Cover.
Figure 4-26.
Screws
Screws
Optional interface cover
HJFK board / Dummy board
Screw
HJFK board / Dummy board
Screws
Screws
Screws
USB
Parallel
Screw
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com