Epson Stylus Pro 10000 - Removing the Paper Release (Pressure Lever) Sensor; Removing the P_FRONT Sensor ASSY

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 180
4.3.3.23 Removing the Paper Release (Pressure Lever) Sensor
1. Remove the R Side Cover as described in 4.3.1.4 "R Side Cover Removal".
2. Push the Paper Hold Lever to the rear. (Lock condition)
Figure 4-158.
3. Unlock five latches of the Paper Release Sensor, then remove it.
4. Disconnect connector cable of the Paper Release Sensor.
Figure 4-159.
4.3.3.24 Removing the P_FRONT Sensor ASSY
1. Remove the R Side Cover as described in 4.3.1.4 "R Side Cover Removal".
2. Remove the Flushing Box as described in 4.3.3.14 "Removing Flushing Box".
3. Looking from rear of printer, disconnect relay connector of P_FRONT Sensor.
Figure 4-160. P_FRONT Sensor Relay connector
Paper hold lever
Paper Release Sensor
Latch
Connector cable
Latch
Relay connector
Rear of Printer
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com