Epson Stylus Pro 10000 - Usb; TYPE-B Optional Interface

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Product Description Interfaces 27
1.3.2 USB
Standard : “Universal Serial Bus Specifications Revision 1.1”
“Universal Serial Bus Device Class Definition for
Printing Devices Version 1.1”
Bit rate : 12Mbps (Full speed device)
Data encoding : NRZI
Adaptable connector : USB series B
Suggested cable length : 2 meters
Figure 1-6. USB Pins
NOTE: To use USB interface: set “PARA.I/F=COMPAT.” in the Printer Settings
Menu.
1.3.3 TYPE-B Optional Interface
Type-B interface (level 2, 1200mA type) is supported.
Reply message (Case of using Type-B I/F card except above):
 Card in Type-B slot 1:
Main type:
MT48p,PW127cl10cpi,PRG(T0xxxx.yyyy.zzzz)rev,SPD0fast
AP1200ma
Product name: Stylus Pro 10000 (pigment: Stylus Pro 10000CF)
Emulation type: ESCPL2-00
Entity type: EPSONLQ2J
 Card in Type-B slot 2:
Main type: MT48p,PW127cl10cpi,PRG(T0xxxx.yyyy.zzzz)rev,
AP1200ma, SPD1fast
Product name: Stylus Pro 10000 (pigment: Stylus Pro 10000CF)
Emulation type: ESCPL2-00
Entity type: EPSONLQ2J
Table 1-19. USB connector pin assignments and signals
Pin no. Signal name In/Out Description
1VCC -
Cable power, max. power consumption is 100mA
2 -Data bi-directional
data
3 +Data bi-directional
data, pull up to+3.3V via 1.5K ohm resistor
4 Ground -
Cable ground
Pin #2
Pin #1
Pin #4
Pin #3
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com