Epson Stylus Pro 10000 - Adjustment Outline; Adjustment;Special Operations

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Adjustment Outline 187
5.1 Adjustment Outline
This chapter describes adjustment items and special operations methods that are
needed during repair.
5.1.1 Adjustment/Special Operations
This section describes relationships between disassembly/replacement parts and
adjustment items and special operations. In addition, the order for adjustment
procedures is specified when several adjustments/special operations are needed.
C A U T I O N
Be sure to follow the order for adjustment procedures. If a
mistake is made in the procedure order, it will be necessary to
perform the adjustments again.
Table 5-1. Repair Items and Required Adjustment Items
Repair Item
Adjustment
Procedure
Adjustment Items Reference
Printhead
replacement
1
2
3
4
5
6
<Start-up the Self-diagnostics>
 Head rank input
 Nozzle check
 Head slant adjustment
 Bi-D adjustment
 Head LR (Gap) adjustment
 Print head life counter clear
5.4.4.3
5.4.4.4
5.4.4.7
5.4.4.8
5.4.4.9
5.4.4.10
5.4.4.11
Ch1-1.8
C362 DRV Board
replacement
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
<C362 DRV Board replacement> *1
 Parameter backup
 Reload firmware
<Start-up the Self-diagnostics>
 Parameter download
 Head rank input
 Bi-d adjustment
 Head slant adjustment
 Paper feed adjsutment
 Top & Bottom adjustment
 Dot missing detection offset adjustment
 Rear sensor volume adjustment
 Front sensor volume adjustment
 Paper edge sensor volume adjustment
 Cutter pressure adjustment
 Replace waste ink pads then clear the ink
counter.
 Write USB-ID
5.2.2
5.2.3
5.2.2
5.4.4.3
5.4.4.10
5.4.4.7
5.4.4.8
5.4.4.9
5.4.4.12
5.4.4.13
5.4.4.6
5.3.8.1
5.3.8.1
5.3.8.1
5.3.10
5.4.4.17
5.2.4
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com