Epson Stylus Pro 10000 - Removing the CR_HP Sensor

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 179
5. Remove two screws securing the HEAD_SLIDE Motor, then remove the PG
motor.
Figure 4-155.
4.3.3.22 Removing the CR_HP Sensor
1. Remove the R Side Cover as described in 4.3.1.4 "R Side Cover Removal".
2. Push the carriage lock using your finger to unlock the carriage and move the
carriage from the home position to the left. (Refer to 4.3.3.3 "Replacing the
Printhead" step 3.)
3. Unlock three latches of the CR_HP sensor, then remove it.
Figure 4-156.
4. Disconnect the cable connector of the CR_HP sensor.
Figure 4-157.
Screws
Latch
Latch
CR_HP sensor
CR_HP sensor
Cable connector
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com