Epson Stylus Pro 10000 - Panel Unit Removal

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 120
4.3.1.1 Panel Unit Removal
1. Push the clips (Refer to Figure 4-5.) on both sides of the panel unit and pull
slightly away from the R Side Cover.
① Push it toward you.
Figure 4-4. Panel Unit Removal 1/2
② Lift it up ③ Lift it up then turn over.
Figure 4-5.
2. Remove the FFC cable from the connector and hook.
Figure 4-6. Panel Unit Removal 2/2
1
Push
2
Connector
3
Clip
Clips
C H E C K
P O I N T
You may find it easy to remove the panel unit if you stand on the
front of the printer and use both hands to pull (squeeze) the panel
towards then lift up. (Refer the above figures and arrow directions.
This way you remove first the rear-side hook, then you can easily
remove it.
Connector
Hook
FFC Cable
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com