Epson Stylus Pro 10000 - Tools for Adjustment;Special Operations

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Adjustment Outline 189
5.1.2 Tools for Adjustment/Special Operations
This section describes about tools that is required by adjustment/special operations for
required adjustment.
NOTE: Except the Phillips screwdriver and the slotted Screwdriver.
Table 5-2. Adjustment Tools
Name Part Code Notes
Tension Gauge #F712
B747700300/
Standard tool
Max. 4000g measurement
User’s data memory card
1050073
Standard
PC card acceptable
Type: 2MB Flash memory card
Standard: Type-II (PCMCIA Rel 2.1/JEIDA
Ver. 4.2)
Voltage: 5V Read/Write
Program data memory
card
• 44 inch roll paper
• Doubleweight Matte
roll paper (44 inch)
EPSON special
media
Necessary for mechanism-adjustment
printouts
A3 Tracing paper
Kimoto brand:
MicroTrace
#300LMB
Necessary to determine P_FRONT and
P_REAR sensor volumes
A3 copy paper Standard paper
Necessary to determine P_EDGE sensor
volume
(+)Screw driver(2) Standard tool
Tension Gauge with
attachment
EPSON special tool 300g
Screw lock tight
Paper thickness gauge
(0.6mm)
Standard tool 0.6 mm
Paper thickness gauge
(0.7mm)
Standard tool 0.7 mm
Precision screw driver Standard tool
Ink discharge cartridge 1060627 Ink type detection
Cleaning liquid cartridge 1060626 Print head and tube cleaning
Cutter positioning tool 1070178 Cutter blade position adjustment
CR-ENC setting tool 1070171 CR-RNC position adjustment
Scale insertion tool 1070174 CR_loop scale fixing
Starter Cartridge Lc 1062231 Stylus Pro 10000 (except EAI market)
Starter Cartridge Lc 1062243 Stylus Pro 10000CF (Except EAI market)
Starter Cartridge Lc 1062237 Stylus Pro 10000 ( EAI market)
Starter Cartridge Lc 1062249 Stylus Pro 10000CF ( EAI market)
Table 5-2. Adjustment Tools
Name Part Code Notes
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com