Epson Stylus Pro 10000 - Start-Up Procedure; Button Operation During the Self-Diagnostics; Top Menu

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Self-Diagnostics 207
5.4.1 Start-up procedure
Following Button operation that triggers self-diagnostic function.
1. Power off condition
2. Press and hold the "Paper Feed +", "Paper Feed -" and "Cut/Eject" button.
3. Turn on the power.
4. The Self-Diagnostics menu is displayed.
5. If you want to finish this mode, turn the printer off.
5.4.2 Button operation during the Self-Diagnostics
The function of panel button at the Self-Diagnostic mode is shown in the Table 5-8.
Table 5-8.
5.4.2.1 Top menu
Top menu sequence is shown below.
Figure 5-12. Top menu sequence
Normal mode Self-diagnostics mode
Pause Previous layer
Select Type Next menu
Item Previous menu
Paper feed + Increment the value
Paper feed - Decrement the value
Enter Fix the value
Cleaning Paper feed & cut (Feed: Press/Cut: Release)
C A U T I O N
 Use the roll paper for self-diagnostics except particular case.
 Cut sheet is handled as a roll paper with self-diagnostics.
 Use following button for self-diagnostics: Pause/SelecType/Item/
Paper feed+/Paper feed-/Enter.
Check : Test
Check : Cleaning
Check : Print
Check : Parameter
Check : Life
Item
Enter
Test menu
Pause
Check : Adjustment
Item
Item
Item
Item
Item
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com