Epson Stylus Pro 10000 - Removing Head Weight Set <Stylus Pro 10600

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 155
4.3.3.4 Removing Head Weight Set <Stylus Pro 10600>
1. Remove Carriage Cover. (Refer to 4.3.3.3 "Replacing the Printhead".)
2. Remove R Side Cover. (Refer to 4.3.1.4 "R Side Cover Removal".)
3. Remove L Side Cover. (Refer to 4.3.1.5 "L Side Cover Removal".)
4. Remove R Inside Cover. (Refer to 4.3.1.6 "I/H Cover ASSY Removal".)
5. Shift Carriage to right end. (Refer to Figure 4-93.)
Figure 4-93. Position for screw removal
6. Insert a 30cm screwdriver through opening created by removal of R Inside Cover.
Remove 1 screw (W Sems M3x8) securing the weight to the Carriage.
Figure 4-94. Screws Securing Weight 1
Insert a 30cm screwdriver
Remove this screw
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com